当前位置: 首页 > 文章 > 秸秆燃料成型机平模的结构改进及寿命分析 农机化研究 2014 (11) 247-249+254
Position: Home > Articles > Structure Improvement and the Fatigue Analysis about the Flat-die of the Straw Fuel Forming Machine Journal of Agricultural Mechanization Research 2014 (11) 247-249+254

秸秆燃料成型机平模的结构改进及寿命分析

作  者:
杜晓龙;葛正浩;李成平;张兴钰
单  位:
陕西科技大学机电工程学院
关键词:
秸秆燃料;平模;模孔;疲劳寿命;挤压成型
摘  要:
针对目前平模成型机平模易磨损、使用寿命短、生产效率低等问题,将平模设计成带有一定的斜度、上下对称结构,模板上交错分布着5排模孔且模孔结构采用锥孔成型直孔保压的方式。同时,利用Pro/Mechanica对平模进行了疲劳寿命仿真分析,得出平模所受最大的应力为348.9MPa,低于材料的屈服极限,最大的位移量为0.331 9mm;平模所能承受的最小应力循环次数为1×104.533次,平模工作区域的寿命置信度为3。最后,通过自制的模具进行挤压成型实验,成型密度平均为1.1g/mm3,最佳的孔径比约为5∶1。
译  名:
Structure Improvement and the Fatigue Analysis about the Flat-die of the Straw Fuel Forming Machine
作  者:
Du Xiaolong;Ge Zhenghao;Li Chengping;Zhang Xingyu;Mechanical and Electrical Engineering College,Shaanxi University of Science and Technology;
关键词:
straw fuel;;flat-die;;die hole;;fatigue life;;extrusion moulding
摘  要:
Aiming at the problems of easy wear,short service life,low production efficiencies and so on about the flatdie of straw fuel forming machine at present,the flat die is design to a certain slope,symmetrical structure,there is five rows of die hole which is used by the way of the taper hole forming and straight hole dwelling on the template.The static strength and the fatigue analysis about the flat die was conducted based on Pro/Mechanica,the peak of stress of flat die is 348.9MPa,well below the material yield limit;the maximum number of displacement 0.331 9m,the minimum number of stress cycles is 1×104.533;the confidence of life of the flat die working area is 3.Finally,through extrusion Moulding text used by self-made mold,the average of density is 1.1g/mm3and the best aperture ratio is about 5:1.

相似文章

计量
文章访问数: 9
HTML全文浏览量: 0
PDF下载量: 0

所属期刊

推荐期刊