当前位置: 首页 > 文章 > 基于机载LiDAR的四次多项式拟合法估测单木冠幅 西北林学院学报 2015,30 (3) 164-169
Position: Home > Articles > Estimating Individual Tree Crown Diameter Using Fourth Fegree Polynomial Fitting Method Based on Airborne LiDAR Journal of Northwest Forestry University 2015,30 (3) 164-169

基于机载LiDAR的四次多项式拟合法估测单木冠幅

作  者:
霍达;邢艳秋;田昕;尤号田;赵晨阳;胡洋
单  位:
中国林业科学研究院资源信息研究所;东北林业大学森林作业与环境研究中心
关键词:
小光斑激光雷达;冠幅;单木;四次多项式拟合;树高
摘  要:
小光斑激光雷达已被广泛用来估测森林参数,为了进一步提高其估测单木的精度,选取了内蒙古依根试验区野外测量的单木数据和机载LiDAR数据,提出了四次多项式拟合法。该方法首先以单木顶点为中心在CHM上提取东西、南北2个方向的高程数据。然后分别得到2组数据的四次多项式拟合曲线,曲线中两凹点之间的水平距离为该方向的冠幅值。最终将2个方向的均值作为单木冠幅估测值,冠幅估测值的平均绝对误差为0.99m。
译  名:
Estimating Individual Tree Crown Diameter Using Fourth Fegree Polynomial Fitting Method Based on Airborne LiDAR
作  者:
HUO Da;XING Yan-qiu;TIAN Xin;YOU Hao-tian;ZHAO Chen-yang;HU Yang;Research Center of Forest Operation and Environment,Northeast Forestry University;Research Institute of Forest Resource Information Techniques,CAF;
关键词:
small-footprint LiDAR;;crown diameter;;individual tree;;fourth degree polynomial fitting;;tree height
摘  要:
Currently,the small-footprint LiDAR has been widely used to estimate forest parameters.In order to further improve the estimate accuracy of individual tree,field measured individual tree data and airborne LiDAR data in Eagan area of Inner Mongolia were selected,and a fourth degree polynomial fitting method was put forward.In the method,firstly,the top of individual tree was centered,elevation data on Canopy Height Model(CHM)at the north-south and the east-west directions were extracted.Secondly,two fourth degree polynomial fitting curves were extracted on the two group data,respectively.The horizontal distance between two pits on the curve was considered as crown diameter at this direction.Finally the crown diameter was calculated as the average of two values measured along two directions.The analysis showed that mean absolute error of individual crown diameter was 0.99 m.

相似文章

计量
文章访问数: 7
HTML全文浏览量: 0
PDF下载量: 0

所属期刊

推荐期刊